Poseidon 3468 je IP termostat podpira dva relejna izhoda, 4 vhodne kontake in 4 senzorje za temperaturo in vlago. Vsebuje tudi spletni strežnik, zunanji nadzor in obveščanje o preseženih vrednosti.

Vrednosti in konfiguracija so na voljo prek spletnega vmesnika, vrednosti pa prek mrežnih protokolov (SNMP, XML, Modbus / TCP in drugi). IP termostat ima funkcijo lokalnega nadzora. 2 izhoda z 250V. 

OSNOVNE ZNAČILNOSTI

Senzorji so povezani preko 1-Wire (RJ11), skupne dolžine napeljave do 30 metrov. Vsak senzor spremlja določene vrednosti in v primeru preseženih vrednosti ali vklopa/izkola kontakta o tem pošlje obvestilo prek e-pošte ali SNMP trap.

Sonde na voljo

Temperatura - Temp-1Wire, sonde različnih dolžin (1, 3 in 10 m)
Vlaga - Humid-1Wire, različne dolžina (1 in 3 m)
PowerEgg kontrola napetosti 
Detektor poplave
Detektor uhajanja plina
Javljalnik dima
Detektor gibanja

Port 1 - Ethernet port 

+ Interface RJ45 (10BASE-T) – 10 Mbit or 10/100 Mbit network compatible+ Supported protocolsIP: ARP, TCP/IP (HTTP, Modbus over TCP), UDP/IP (SNMP)+ SNMP compatibilityVer:1.00 compatible, some parts of the ver 2.0 implemented Port 2 - 1-Wire sensor bus + Connector RJ12 (6 pins - 4 pins used only)+ Sensors / distance model 3265 - max. 5 sensors, up to 10 m total
model 3262 - max. 2 sensors, up to 10 m total Port 3 - Dry contact inputs + 4 Contact inputs Connect it with a contact directly (dry contact).+ IsolationGalvanic isolated up to 50V DC+ Sensor type NO or NC contact switch+ Max distance Up to 30 m Port 4 - Relay switch outputs + 2 Digital outputs Control via network (Web, XML, SNMP) or signal local alarm+ IsolationRelay switch up to 50V DC, max DC current 24V/1A, 50V/0.5A+ Switch type 3 pins, can be used as NO or NC contact switch LED Status indicators+ POWERGreen - power OK+ LINK & ActivityYellow - Ethernet connectivity DIP SWITCH configuration+ DIP1   - RS--232 Setup modeNot used+ DIP2   - SecurityON   = Security mode - remote configuration disabled
OFF = Non-Security mode - remote configuration enabled Physical parameters + Voltage requirements9 - 15V / 250 mA DC
coaxial power connector (barrel), GND on the shield+ Dimensions 35 x 101.6 x 76.2 [mm] (H x W x D )+ Weight 150 g Functional parameters Device SETUP configuration possibilities - UDP Config - IP address assign via UDP with using PN Eye
- TCP Setup - Terminal configuration and sensors management
- WWW Setup - HTTP Flash application
- SNMP (just for some parameters)